Security Seal Installation; Pressure Sensitive Security Seal - Metrologic MS2020 Stratos Installation And User Manual

S O
CALE PERATION
S S
ECURITY EAL
The certification of the weighing mechanism of the scale version of this
scanner is subject to federal, state and local Weights and Measures
statutes and regulations and can only be performed by authorized
government agencies and/or their duly registered agents. Each time the
scale or weighing mechanism is calibrated, it should be properly sealed
with a paper seal or a wire seal prior to being placed into service in
commerce.
It is the responsibility of the owner of the scale to confirm compliance
with the relevant Weights and Measures statutes and regulations
applicable in your area by checking with the appropriate government
agency before placing a newly calibrated unit into service or removing
any official seals.
Type of seal to be used will depend on the guidelines specified by the
local Weights and Measures authorities.
The security seal must only be installed if there were no errors during the scale
calibration verification tests.

Pressure Sensitive Security Seal

1. Temporarily remove the platter and place it in a safe location.
2. Reinstall the calibration switch/button cover.
84
I
NSTALLATION
Figure 81. Calibration Switch/Button Cover