Metrologic Ms1633 Scanner Setup (Usb Bluetooth Adapter); Metrobt Driver Installation - Metrologic MS1633 FocusBT Installation Manual

Metrologic MS1633 Scanner Setup (USB Bluetooth Adapter)

If you are installing your MS1633 scanner using the Metrologic USB Bluetooth Adapter on your
PC please perform the following steps. If you are installing your MS1633 scanner using the
USB CodeXML Modem please move to that section of this document as the instructions in this
section are not designed for your scanner.
To install the Metrologic MS1633 FocusBT scanner with a Bluetooth adapter you will need to
load 3 software applications on your PC. These applications are on the CD that came with your
scanner.
MetroBT Driver, MetroBT Utility, SoftWedge
Note: This installation document is used as a guide, the information should be the same but the
screens may very.

MetroBT Driver Installation

1) Load the included FocusBT CD into the CD-ROM drive on the host / computer.
2) If the CD-ROM does not automatically open, click on the window's Start button, choose
Run, then click Browse to locate and open the CD-ROM drive. Double-Click on the
Metrologic.exe file then click OK.
MetroBT Driver
3) Click on the
10 MS1633 Focus BT Scanner Installation Guide
© Cerner Confidential and Proprietary All rights reserved. This document contains confidential information, which may not be
reproduced or transmitted without the express written consent of Cerner Corporation.
button to begin the installation.