Procedure To Update The Firmware - Toshiba GSC-R60 Service Manual

6-3-9. Procedure to Update the Firmware

Devices to use
- Dedicated power supply (accessory)
- SD card
For firmware writing
Notes
- There are two procedures to update the firmware. If the Procedure 1 would not work successfully, try the
Procedure 2 to update the firmware.
- Toshiba provides the latest firmware as soon as the version is updated. It is recommended to always use
the latest version.
- "GSCR20.bin" is only the file provided with the firmware version renewal. The "UP_R20.bin" is an auxiliary
firmware used for writing "GSCR20.bin" in under the Procedure 2. It is recommended to use the same file.
- When the power is shut down accidentally during the update, the system may not start even after rebooting
the power. In that case, it is necessary to update the firmware with following the Procedure 2.
Procedure 1
1) Write the firmware for update (file name: GSCR20.bin) to the root directory of SD card.
2) Connect the AC adapter and insert the SD card to the camera.
3) Turn on the camera.
4) Press the MENU button and select "SETUP" -> "SYSTEM" -> "VERSION INFORMATION" from either the
recording menu or the playback menu. The version information should be displayed on the monitor. (Fig.
6.3.9.1).
4) The screen shown in Fig. 6.3.9.2 will be displayed by holding the movie REC button for several seconds.
Then, the update will start.
5) The update is completed when the message "COMPLETED" is displayed on the monitor screen (Fig.
6.3.9.3). Then, turn the power off.
6) Turn on the power again and confirm if the version information on the title screen is updated (Fig. 6.3.9.4).
Fig. 6.3.9.1
Fig. 6.3.9.3 Fig. 6.3.9.4
50
Fig. 6.3.9.2