Toshiba GSC-R60 Service Manual page 33

Step Figure
34
35
36
37
38
39
40
Discription
From the THERMINAL PCB ASSY
(UA11) to the MAIN PCB ASSY (
U001) Connected FPC remove
from the connector and pull out
the Cradle terminal from Main
Cover ASSY (AA01).
Remove the A325.
Remove the TERMINAL PCB
ASSY (UA11).
Remove the screws A326*2.
Remove the EMI Sheet A (A349)
and EMI Sheet B (A350).
Remove the screws A326*2.
Remove the SENSOR PCB ASSY
(U006) of FPC from the
connector.
Raise the MAIN PCB ASSY
(U001) and remove the connector
as shown.
Remove the MAIN PCB ASSY.
Detach the MAIN PCB ASSY
(U001) and FLASH-MAIN FPC
(W999).
Remove the EMI Sheet C (A351).
Remove the screws A332*4, A325
and Battery Case ASSY (AC11).
32
Remark
TERMINAL PCB ASSY (UA11)
does not separate yet at this time,
be careful not to cut FPC.
EMI Sheet C (A351) is separate at
this time, be careful not to lose.
This work is unnecessary when
not exchanging the MAIN PCB
ASSY (U001) and FLASH-MAIN
FPC (W999).