Zoom/Focus - Toshiba GSC-R60 Service Manual

6-3-7. Zoom/Focus

Devices to use:
- Dedicated power supply (accessory)
- Lens hood
- SD card
The SD card needs to contain the adjustment firmware. Make sure the firmware is written to root
directory.
- Collimator
1) Confirm that the AC adapter is connected, lens food is attached, and SD card with adjustment firmware is
inserted to the camera.
2) Place the camera in the position where the distance between the lens side of collimator and the lens side of
the camera can be approximately 2 to 3 cm.
3) Turn on the camera with holding the MENU button.
4) The adjustment menu shown in Fig. 6.3.7.1 will be displayed on the LCD monitor. Select "ZOOM/FOCUS"
by rotating the JOG dial or by pushing up/down the OK button, and press the OK button down to right to
proceed.
5) The image shown in Fig. 6.3.7.2 will be displayed on the LCD monitor. Adjust the camera position to make
the cross on the screen overlapping with the center of the chart.
6) Press the OK button to proceed.
7) After the automatic adjustment, the result will be displayed at the bottom of monitor screen within several
seconds. As shown in Fig. 6.3.7.3, the adjustment is completed when "SUCCESS" is displayed. As shown
in Fig. 6.3.7.4., the adjustment is failed when "FAILURE" is displayed, and re-adjustment will be required.
8) Turn off the power of the camera to complete the adjustment.
Fig. 6.3.7.1
Fig. 6.3.7.3
48
Fig. 6.3.7.2
Fig. 6.3.7.4