Toshiba GSC-R60 Service Manual page 37

Step Figure
14
15
16
17
18
19
20
Discription
Open the Battery Cover. Use
screw A325 and install the Switch
PCB of the TERMINAL PCB
ASSY (UA11).
Connect the TERMINAL PCB
ASSY (UA11) of FPC to MAIN
PCB ASSY (U001).
Insert the Cradle Terminal of
TERMINAL PCB ASSY (UA11) to
Main Cover ASSY (AA01) and fix
with screws A327*2.
It sticks on a TERMINAL PCB
ASSY (UA11) in order of Shield
Gasket B (A356) and Shield
Gasket A (A355).
Connect the LENS-MAIN FPC
ASSY (UA09) to Lens Module
ASSY (HA52) and install the Lens
Cushion (A306*4) and Lens
Holder (A305).
Tapes are stuck as shown.
The position of a Lens Cushion
(A306) is united and a lens block
is set to Main Cover ASSY
(AA01).
The position of Main Cover ASSY
(AA01) is united with a Lens
Holder (A305). (Two positionings).
36
Remark
Check the switch lever moves
when the battery cover that open
and close.
Be careful not to cut FPC.
The connector of FPC is an upper
point of contact.
Do not stick on the moving part of
connector.
Be careful to be unable to touch a
lens side.
When a Lens Cushions (A306)
tends to be omitted, it attaches in
a Main Cover ASSY (AA01) side.