Table of Contents
Advertisement
8
Start inhibitor
.04
8
Mounting the start inhibitor
.04.01
Fig. 8 - 05
For machines delivered without a table, the plate 1 from the accessories should be
mounted, so that it is on a level with the bottom edge of the table top and with the left
edge of the table top cutout.
Set the machine into the table top.
After loosening screws 3, move switch 2 until it is touching plate 1.
In this position tighten screws 3.
8
Checking the function of the start inhibitor
.04.02
Switch the machine on at the main switch and tilt it over.
The error message "E009" must appear on the control panel.
If the message does not appear, check the setting of the start inhibitor as described in
Chapter 8.01.04 Mounting the start inhibitor.
Set the sewing head upright and acknowledge the error message.
The machine is ready for operation again.
Mounting and commissioning the machine
3
2
ERROR
E009
PRESS TE-SPEED
1
8 - 5
Advertisement
Table of Contents
