Table of Contents
Advertisement
Adjustment
13
Setting the zero point of the feed regulator
.05.14
13 - 16
Requirement
When the stitch length is set at "0", at maximum speed (4500 spm) the needle should
always penetrate in the same place.
Unthread the machine.
Switch on the machine.
Place the workpiece under the presser foot.
Let the machine sew at maximum speed and
check the requirement.
(The workpiece should not move).
Change the value for parameter 834 within the permissible values in accordance with the
requirement.
TE
No
834
The permissible values for parameter 834 are "1", "0" or "-1".
If the zero point of the feed regulator cannot be set by selecting one of the
permissible values, the mechanical setting must be checked or corrected, see
Chapter 13.05.03 Zero position of the bottom feed dog.
The zero position of the feed regulator is always recognisable in a range of 3
values. When making the adjustment, select the middle value.
Switch off the machine.
Find more information on how to select and alter parameters and about
descriptions (functions) of the individual parameters in Chapter 13.11 Parameter
settings.
VAL
0
Advertisement
Table of Contents
