Replacing The Azimuth Motor - KVH Industries TracVision G8 Owner's Manual

TracVision G8 Owner's Manual - Guide to Technical Information
Figure 5-23
Azimuth Motor Cable
Figure 5-24
Azimuth Motor (Shield Removed)
108

5.12 Replacing the Azimuth Motor

1. Disconnect the motor cable from the azimuth
motor.
Motor Cable
Connector
Azimuth Motor
2. Remove the motor shield by pressing on the two
sides of the shield above the release tabs.
3. Remove the four #8-32 screws, locking nuts, and
washers securing the motor to the antenna frame.
Remove the old azimuth motor.
#8-32 Screws
(x 4)
Release Tab
Azimuth Motor
54-0198