Daikin FTK25JVE9 Service Manual page 57

Instruction
AUTO • DRY • COOL • HEAT • FAN Operation
The air conditioner operates with the settings of your
choice.
From the next time on, the air conditioner will operate
with the same settings.
1
MODE
Press
l
Each pressing of the button advances the mode setting
in sequence.
<FTK>
<FTX>
2
ON/OFF
Press .
ON
OFF
n
To stop:
ON/OFF
Press once again.
Then OPERATION lamp goes off.
n
To change the temperature setting:
DRY or FAN mode
Press
press
Set to the temperature you like.
The temperature
setting is not vari-
able.
8
48
and select a mode.
Then OPERATION lamp lights up.
AUTO or HEAT or COOL mode
to raise the temperature and
to lower the temperature.
C
To change the air flow rate setting:
Press .
FAN
DRY mode AUTO or HEAT or COOL or FAN mode
Five levels of air flow rate setting from
" " to "
The air flow rate
setting is not
variable.
l
At smaller air flow rates, cooling or heating effect is also
smallwer.
n
To change the air flow direction:
(See page 50.)
NOTE
<Note on HEAT mode operation>
Since this air conditioner heats the room by taking heat from
outdoor air to indoors, the heating capacity becomes smaller in
lower outdoor temperatures. If the heating effect is insufficient, it
is recommended to use another heating appliance in
combination with the air conditioner.
The heat pump system heats the room by circulating hot air
around all parts of the room. After the start of heating operation,
it takes some time before the room gets warmer.
In heating operation, frost may occur on the outdoor unit and
lower the heating capacity. In that case, the system switches
into defrosting operation to take away the frost. During
defrosting operation, hot air does not flow out of indoor unit.
<Note on DRY mode operation>
This operation dehumidifies the indoor air when it is humid.
<Note on AUTO operation>
In AUTO operation, the system selects a temperature setting
and an appropriate mode (COOL or HEAT) based on the room
temperature at the start of the operation.
The system automatically reselects setting at a regular interval to
bring the room temperature to user-setting level.
If you do not like AUTO operation, you can select manually,
you like the mode and setting.
Si04-115
"plus " " are available.
(R1930)
System Configuration