Fujitsu ETERNUS2000 Connection Manual page 4

Preface
• Chapter 6 Installing the SAS Card Drivers
This describes how to install the SAS card drivers and set up the server.
• Chapter 7 Setting Up the Server
This describes how to connect the server and ETERNUS Disk storage systems.
• Chapter 8 LUN Recognition
This describes how to recognize the ETERNUS Disk storage system logical units from server.
• Chapter 9 Setting Up and Checking the ETERNUS Multipath Driver
This describes how to set up and check the ETERNUS Multipath Driver.
• Chapter 10 Setting Up and Checking the device-mapper multipath
This describes how to set up and check the device-mapper multipath.
• Chapter 11 Setting Up the File System
This describes how to create a file system on the ETERNUS Disk storage systems.
Safe Use of this Product
■
Using this manual
This manual contains important information to ensure the safe use of this product. Be sure to
thoroughly read and understand its contents before using the product. After reading, store this
manual in a safe place for future reference.
FUJITSU has made every effort to ensure the safety of the users and other personnel, and to
prevent property damage. When using this product, carefully follow the instructions described in
this manual.
Acknowledgments
• Linux is a trademark or registered trademark of Linus Torvalds in the USA and other
countries.
• Red Hat, PRM, and all Red Hat-based trademarks and logos are trademarks or registered
trademarks of Red Hat, Inc. in the USA and other countries.
• SUSE is a registered trademark of SUSE Linux AG., a subsidiary of Novell, Inc.
• LSI and the LSI logo design are trademarks or registered trademarks of LSI Logic
Corporation or its subsidiaries.
• The company names, product names and service names mentioned in this document are
registered trademarks or trademarks of their respective companies.
P3AM-4212-02ENZ0 ETERNUS2000 Disk storage systems Server Connection Guide (SAS) for Linux
4
Copyright 2010 FUJITSU LIMITED