Yamaha TMax XP500 Owner's Manual page 59

1
1. Torque wrench
6. Install the new oil filter cartridge,
and then tighten it to the speci-
fied torque with a torque wrench.
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf)
7. Install the engine oil drain bolt,
and then tighten it to the speci-
fied torque.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf)
Ofrecido por www.electromanuales.com
PERIODIC MAINTENANCE AND MINOR REPAIR
8. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil
filler cap.
Recommended engine oil:
SAE 10W-30 or SAE 10W-40
(API SE, SF, SG or higher)
Oil quantity:
Without oil filter cartridge
replacement:
2.8 L
With oil filter cartridge
replacement:
2.9 L
Total amount (dry engine):
3.6 L
cC
6-14
8 8 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives.
Do not use oils with a diesel
specification of "CD" or oils of
a higher quality than specified.
In addition, do not use oils
labeled "ENERGY CONSERV-
ING II " or higher.
8 8 Make sure that no foreign
material enters the crankcase.
9. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the
engine off and check for the
cause.
10.Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA00133
6