Removing The Clamp Brackets; Installing The Clamp Brackets - Yamaha F100C Service Manual

BRKT

Removing the clamp brackets

1. Remove the power trim and tilt unit. For
removal procedures, see "Removing the
power trim and tilt unit" in this chapter.
2. Remove the anode 1.
3. Loosen the self-locking nuts 2 and bolt
3, and then remove clamp brackets 4
and 5.
4. Remove the trim sensor 6.

Installing the clamp brackets

1. Install the trim sensor 1 onto the swivel
bracket assembly.
LT
271
7-67
Bracket unit
S60C7265
S60C7160
NOTE:
Adjust the trim sensor after installing the
power trim and tilt unit.
2. Assemble the clamp brackets and the
swivel bracket by installing the anode 2,
bolt 3, and self-locking nuts 4, then
tightening the nuts to the specified
torque.
A A
A A
Self-locking nut 4:
15 N·m (1.5 kgf·m, 11 ft·lb)
3. Install the power trim and tilt unit. For
installation procedures, see "Installing
the power trim and tilt unit" in this chap-
ter.
LT LT
572
A A
S60C7270
60C5D11