Installing The Power Trim And Tilt Motor - Yamaha F100C Service Manual

BRKT
NOTE:
Place a clean cloth over the end of the arma-
ture shaft, hold the shaft with a pair of pliers
as shown, then carefully slide the yoke onto
the armature.
Installing the power trim and tilt
motor
1. Install the filter 1 and joint 2 into the
pump housing.
2. Fill the pump housing a with the recom-
mended fluid to the correct level as
shown.
Recommended power trim and tilt
fluid:
ATF Dexron II
7-47
Bracket unit
3. Remove all of the air bubbles with a
syringe or suitable tool.
NOTE:
Turn the joint with a screwdriver, and then
remove any air between the pump gear teeth.
4. Install the new O-ring 3, power trim and
tilt motor 4, and then tighten the bolts 5
to the specified torque.
NOTE:
Align the armature shaft with the recess in
the joint.
PTT motor bolt 5:
5 N·m (0.5 kgf·m, 3.6 ft·lb)
5. Remove the reservoir cap.
6. Fill the reservoir b with the recom-
mended fluid to the brim of the filler hole
as shown.
Recommended power trim and tilt
fluid:
ATF Dexron II
60C5D11