Sony SR-R4 Operation Manual page 67

Warning messages
Code Message Meaning
W001 PB FREQ There is a mismatch
MISMATCH between the configured
system frequency and the
frequency information
recorded on the playback
file.
W002 PB FMT There is a mismatch
MISMATCH between the configured
system format and the
format information
recorded on the playback
file.
W007 REC INHIBIT Unit is in a non-record
MODE mode or SYSTEM
settings are being
configured.
W009 TEMPERATURE The temperature within
LOW the unit has fallen below
the rated value. Warm-up
the unit.
W00C CP MISSING Cannot detect a signal
from the control panel.
W00D DC VOLTAGE Detected a drop in the
LOW supply voltage.
W00E BOARD The temperature inside
TEMP HIGH the unit is too high.
W010 MEDIA FULL Cannot record because
the SRMemory card is
full.
W011 TOO MANY The number of files on
FILES the SRMemory card
exceeds the maximum
value.
W012 COND3 BAD Cannot record due to
insufficient bad memory
swap area on the
SRMemory card.
W013 LID OPEN The SRMemory card
insertion slot lid is open.
W017 MEDIA Detected an SRMemory
REMOVED card connection failure.
W018 MARK IN
Previous MARK IN data
FULL was overwritten due to the
limit on the number of
MARK IN points for a
single file being exceeded.
W019 ILLEGAL A file name containing
FILENAME prohibited characters was
received. Rename the file.
Code Message Meaning
W01A TASK STUCK Transmission for a
portion of a multitask
may have failed.
W01F PLAYER Recording is not possible
MODE in the current state.
W022 AUDIO PLL The audio clock is not
UNLOCK locked to the reference
video signal.
W024 INTERNAL Internal Frm interruption
FRM NG could not be processed
properly.
W02F LOST LOCK Detected a loss of lock
synchronization during
recording or playback.
W039 NO AUX No input on the AUX IN
INPUT connector.
W03B AUX IN "AUX IN" is selected in
UNLOCK the AUDIO menu, but the
input signal of the AUX
IN connector and the
video signal input to the
unit is not locked.
W03D ENCODER Encoder initialization
NG failed.
W03E ENC Recording malfunction
WARNING (encoder error).
W03F DEC Cannot playback data
WARNING from SRMemory card
(decoder error).
W050 WP SW ON The SRMemory card
write-protect switch is set
to WP.
W051 FS LOCKED The SRMemory card is
set to FS LOCK in the
SYSTEM menu.
W054 CONDITION Detected an SRMemory
NG card access error.
W055 PB NOT Not ready for playback.
READY Playback the file again.
W070 CAM ERROR An error occurred in the
camera. Check the settings
on the camera display.
W071 CAM A warning occurred in the
WARNING camera. Check the settings
on the camera display.
W072 CAM NOT Recording cannot start
READY due to problems with the
camera.
W073 CAM ID The CAM ID setting in
MISMATCH the FILE NAME menu
and the card information
do not match.
Error Messages and Warning Messages
67