Error Messages And Warning Messages; About Error Messages - Sony SR-R4 Operation Manual

Error Messages and
Warning Messages

About Error Messages

When the system stops operating incorrectly
because of an internal error, a warning tone
sounds and a popup window appears in the
display of the control panel with an error
message.
Tip
Only one message is displayed at one time, even if
multiple errors occur. The number of current errors
appears at the bottom of the popup window. Be sure to
check the messages for all errors.
Example:
Popup window displaying error message "E010:
FAN STOP" (fan stopped)
dB
SDI SDI SDI SDI SDI SDI SDI SDI
0
-10
-20 ER RO R
-30
-60
EMP EMP EMP EMP EMP EMP EMP EMP
EE
L R L R L R L R L R L R L R L R
1 2 3 4 5 6 7 8
E010 E010
FAN STOP FAN STOP
PLAY LOCK
TCR LTC INTRP DF
00 00 00
FAN Stopped
H M
TC AU
IN DLY:
1 Error(s)/
FILENAME:(NEXT)A001C001_120530RT FILENAME:(NEXT)A001C001_120530RT
16.5V REMAIN ENCODE
STANDARD
10min
Indicates that there is one
current error message.
Indicates that there are two current
warnings (see page 66).
To view the other messages, rotate the
SELECT/ENTER dial on the control panel.
When an error message appears
Eliminate the cause of the error, and power the
system off and on again.
If the same error message appears again when the
system is powered on, contact a Sony service
representative.
SDI SDI SDI SDI SDI SDI SDI SDI
EMP EMP EMP EMP EMP EMP EMP EMP
L R L R L R L R L R L R L R L R
9 10 11 12 13 14 15 16
VTR OOOOO
EXT-LK KEYINHI
00
RECINHI
S F
MK: --:--:--:--
2 Warning(s)
LOCAL
F65RAW
EE
23.98P
21:46
To close the error message popup window
Press the HOME button or the BACK button.
The error code is shown in the operation status
and warnings section of the HOME screen (see
page 13) and at the bottom left of each Setup
menu screen (model name display) until the cause
of the error is removed.
Error messages
Refer to the Maintenance Manual for more detailed
information about the content of error messages, and
about errors not listed here.
Code Message Meaning
E003 SY NVRAM Detected an FRAM
ERROR (HOURS METER and
TC related information)
checksum error.
E00B SY-AU I/F Detected a
ERROR communication error
between the audio circuit
and system CPU.
E00E SY-CP I/F Detected a
ERROR communication error
between the system CPU
and CP CPU.
E00F PM STATUS Detected an internal
ERROR status mismatch.
E010 FAN STOP Detected a cooling fan
failure.
E013 DC IN Detected an overcurrent
OVERLOAD condition in the power
supply input stage.
E014 DC VOLTAGE The power supply
DOWN voltage dropped below
the rated value.
E017 ILLEGAL The power was
SHUTDOWN previously turned off
without proper
unmounting (i.e.,
ejecting) of the current
card.
E018 BOARD The temperature within
TEMP NG the unit exceeds the rated
value.
E01B DUPLICATE Detected a file name
FILES duplication.
E031 ENCODER The encoder has detected
FAIL a recording error.
E050 MEDIA IF Cannot communicate
ERROR with the SRMemory
card.

Error Messages and Warning Messages

65