Table of Contents
Advertisement
Top cover camshaft assembly removal
See
"Top cover camshaft assembly" on page 7-13
1.
Remove the top access door 24 V interlock switch. See
removal" on page
2.
Remove the left cover. See
3.
Rotate the lever arm (A) all the way up as if the top access door were open; hold the lever arm (A) in place,
and rotate the camshafts (B) down to the closed position.
4.
While still holding the lever arm (A) up, remove the left front mounting screw (C) and flip the right lock (D)
back.
5.
Continue to hold the lever arm (A) up, and remove the right front mounting screw (E); release the lever arm.
6.
Remove the e-clip (F).
7.
Slide the lever arm (A) and the spring (G) off the shaft.
Warning: When removing the right rear mounting screw, be careful not to damage or remove the spring
that mounts over the screw.
8.
Remove the rear mounting screws (H).
9.
Remove the top cover camshaft assembly.
4-98.
"Left cover removal" on page
for the part number.
"Top access door 24 V interlock switch
4-20.
5022-xxx
4-99
Repair information
Advertisement
Table of Contents
