Operator Panel Assembly Removal - Lexmark C52 series Service Manual

Operator panel assembly removal

See "Operator panel assembly, C52x" on page 7-3
part numbers for the C53x models.
Warning: When replacing any one of the following components:
•
Operator panel assembly
•
System card
•
Smart chip card (C52x) or printhead assembly (C53x)
Only replace one component at a time. Replace the required component, and perform a POR before
replacing a second component listed above. If this procedure is not followed, the printer will be
rendered inoperable.
1.
Remove the outer bezel. See
2.
Remove the screw (A).
3.
Disengage the upper locking tabs (B).
4.
Disconnect the cables (C). For model C534: remove cables (C) and the USB cable (D).
B
"Operator panel outer bezel removal" on page
A
Models C52x
C
for the part number. See the same page for the individual
Models C53x
(Model C534 shown)
B
D C
5022-xxx
4-21.
4-23
Repair information