Pm Control By Apm; Modem Use Irq; Video Off Method; Suspend Mode - Transcend TS-ALR4 User Manual

39

• PM Control by APM

When "Yes", an Advanced Power Management device will be activated to enhance the Max.
Power Saving mode and stop the CPU internal clock.

• MODEM Use IRQ

You can select one of the following interrupt resources for modem use: "N/A", "3", "4", "5",
"7", "9", "10", and "11".

• Video Off Method

Defines the Video Off features
-Blank Screen: Only blanks the screen. Use this for monitors without power management
and "green" features.
-V/H SYNC+Blank: Blanks the screen and turns off vertical and horizontal scanning
-DPMS Support: The DPMS (Display Power Management System) feature allows the
BIOS to control the video display card if it supports the DPMS feature.

• Suspend Mode

After the selected period of system inactivity (1 minute to 1 hour), all devices except the
CPU will be shut down.

• HDD Power Down

After the selected period of system inactivity (1 to 15 minutes), the hard disk drive powers
down while all other devices remain active. This feature doesn't effect SCSI hard drives.
• Soft-Off by PWR-BTTN
When set to "Instant-off", the ATX switch can be used as a normal system Power Off button.
When set to "Delay 4 seconds", you need to press the Power-Off button down for more than
4 seconds if you want to Power Off the system.
• Wake-Up by PCI & WOL
Select "Enabled" if you want to Power On your system when a PCI or LAN event occurs.

• Power On by Ring

Select "Enabled" to Power On your system when the external MODEM receives a call.
NOTE:This function requires an external MODEM which supports the Ring Wake-Up
function.
BIOS SETUP