Table of Contents
Advertisement
25
• IDE HDD Auto-Detection : Detect the HDD on this channel. If the detection is successful,
it fills the remaining fields on this menu.
• IDE Primary/Secondary Master/Slave : We recommend that you select "AUTO" for all
drives. The BIOS can automatically detect the specifications during POST (Power On
Self Test) while the system boots. You can also choose "Manual" to set the specifications
by yourself. The "None" setting means there is no device installed on this IDE channel.
• Access Mode : "Normal", "LBA", "Large", or "Auto".
- Normal : Maximum number of cylinders, heads, and sectors supported are 1024,16,
and 63 respectively.
- LBA (Logical Block Addressing) : During drive access, the IDE controller transfers
the data address described by sector, head, and cylinder number into a physical
block address. This will significantly improve data transfer rates for drives with
more than 1024 cylinders.
- Large : For drives that do not support LBA and have more than 1024 cylinders.
- Auto : The BIOS automatically determines the optimal access mode.
• Capacity : Disk drive capacity. Note that this size is slighty greater than the size of
formatted disk given by the disk-checking program.
• Cylinder : Number of cylinders
• Head : Number of heads
• Precomp : Write precompensation cylinder
• Landing Zone : Landing zone
• Sector : Number of sectors
• Drive A / Drive B
Select the correct types of diskette drive(s) installed in the computer.
- None : No diskette drive installed
- 360K, 5.25 in. : 5-1/4 inch standard drive; 360 kilobyte capacity
- 1.2M, 5.25 in. : 5-1/4 inch high-density drive; 1.2 megabyte capacity
- 720K, 3.5 in. : 3-1/2 inch double-sided drive; 720 kilobyte capacity
- 1.44M, 3.5 in. : 3-1/2 inch double-sided drive; 1.44 megabyte capacity
- 2.88M, 3.5 in. : 3-1/2 inch double-sided drive; 2.88 megabyte capacity
BIOS SETUP
Advertisement
Table of Contents
