Init Display First; Power On Function - Transcend TS-ALR4 User Manual

• • • • • On-Chip USB Controller
Select "Enabled" if you have a USB Keyboard or any USB device.
• • • • • USB Keyboard Support
Select "Enabled" if you went to use a USB Keyboard.

• Init Display First

This item allows you to decide whether to activate either the "PCI Slot" or the "AGP" first.
• • • • • IDE HDD Block Mode
Block Mode is also called Block Transfer, Multiple Commands, or Multiple Sector Read/
Write. If your IDE hard drive supports Block Mode (most new drives do), select "Enabled"
for automatic detection of the optimal number of Block Read/Writes per sector that the drive
can support.

• Power On Function

- Password : Power On only if you key in correct password.
- Hot Key : You can use the hot key to Power On the system.
- Mouse Left : Power On with the Mouse Left Button.
- Mouse Right : Power On with the Mouse Right Button.
- Any Key : Press any key to Power On the system.
- Button only : Power On only by pushing the button on the case (Default).
- Keyboard 98 : You can Power On system by pushing the [Power-On] key of Keyboard 98.
• • • • • KB Power On Password
Enter the Power On Passward here. Activated only when "Password" item is selected
in the Power On Function Menu.
NOTE: If you want to use this function, please make sure that the "KB-AWK" jumper
is set to "Enabled".
• • • • • Hot Key Power On
Choose [CTRL] +[ F1] ~ [F12] as a hot key to Power On the system. Activated only when
"Hot Key" is selected on the Power On Function Menu.
and "Auto". The second serial port shares resources (address and IRQ) with IrDA.
BIOS SETUP
34