Wake-On-Lan Connector; Wake-On-Modem Connector - Transcend TS-ALR4 User Manual

HARDWARE INSTALLATION
14
2.10 Wake-on-LAN Connector (3-pin WOL)
This connector connects to LAN cards with a Wake-on-LAN output. The system can Power up
when a wakeup packet or signal is received from the LAN card.
NOTE: This function requires that the "LAN Wake Up" function in the POWER MANAGEMENT
SETUP is set to "Enabled" and that your system has an ATX power supply with
at least 720mA +5V standby power.
WOL (CN13)
+5 Volt Standby
GND
PME

Wake-On-LAN Connector

2.11 Wake-on-Modem Connector (3-pin WOM)
This connector allows the system to be powered up upon receipt of a call via the modem.
NOTE: This function requires a modem which supports the Ring Wake-Up function (see
page 44) and that your system has an ATX power supply with at least 720MA+5V
standly power.
WOM (CN13)
+5 Volt Standby
GND
PME

Wake-On-Modem Connector