Remote Control - Dimplex LBW 300 Installation And Operating Manual

In switch position I it is
possible to activate a
supplementary heat source
"Heat exchanger" switch
Temperature display see above

6.2.2 Remote control

The wall-mounted remote control (Fig. 7) enables the HPWH to be switched on and off as well any one of the
three fan speed settings to be selected (see Table).
Slide switch Description
1
Hot water preparation by heat pump
Selection of fan speed (fan setting
2
The remote control
connection, it is recommended that the housing be installed
over a flush box (mounting instructions are supplied with the
remote control).
The connection between HPWH and remote control is to be
effected by customers using a 6-pole connecting lead (see
section "Electrical connection").
* Heat pump operation cannot be activated or deactivated
from the remote control unless the "heat pump" switch was
activated on the unit beforehand.
Note: Continuous operation of the electric heating element
cannot be controlled via remote control (see section 5.3 "External
immersion heater control")
In switch pos. I the immersion heater is
continuously switched on, in pos.
immersion heater is in the automatic mode
"Immersion heater" switch
*
is surface-mounted.
the
* a
nd fan On /Off
= 95 m³/h, II = 185 m³/h, III = 300 m³/h)
To facilitate
11
Switch position O Æheat pump is
OFF , in switch position
the heat pump is in operation
"Heat pump" switch
Fig. 6: Operating panel
( *
shown is the operating panel of
the HPWH with internal heat
exchanger; on HPWH without internal
heat exchanger the "heat exchanger"
switch is dispensed with )
1
Fig. 7 : Remote control
å å å å /
2