Table of Contents
Advertisement
3 Introduction
Thank you for choosing this product. The Edel Air Source
Heat Pump water heaters are specified with high quali-
ty, immersion heaters for fast reheat times. They boast
50mm of low GWP insulation foam, together with 100%
recyclable stainless steel inner components and a hard
wearing outer shell manufactured from completely recy-
cled materials.
Note:
This product has been designed specifically for the
purpose of delivering heated, domestic and sanitary
hot water as part of a pressurised water heating
system. The package is provided with fittings that
comply with Section G3 of Building Regulations.
Dimplex cannot take responsibility for
ensuring safe operation of the appliance
outside of the scope of intended use.
3.1 Control App
This product is Dimplex Control capable * .
Control and monitor your heating and hot water with Dim-
plex Control. Group appliances into zones to easily control
and track their energy usage. Any time. Anywhere.
Search for Dimplex Control on your device's app store.
*A Dimplex Hub is required for this product to connect to
Dimplex Control. For instruction on setting up Dimplex Hub,
please refer to the manual. Manuals can be downloaded at
Dimplex.co.uk.
4 Scope of Delivery
Table 1: Scope of Delivery for Edel RF Hot Water Heat Pump
* These items are supplied factory fitted
5 Pre-Installation Advice
Please read the following section carefully before
commencing installation. If in any doubt, please call the
appropriate help desk. Disregarding the instructions given
in this manual in its entirety and any relevant regulations,
standards and codes of practice will void the guarantee of
this product.
5.1 Handling
The upper covers of the appliance are not made to
withstand force and should not be used for
handling purposes.
If tipped, the centre of gravity will shift
towards the top: handle with care.
Please note that handling, installation and use of this
product is subject to the Health and Safety at Work Act.
If the unit is not installed immediately, it should remain
in its protective packaging with all pipe protectors/end
caps applied to prevent damage and dirt deposit inside
the water heater and the coil.
Pre-Installation
Non-permitted transport positions:
Transporting the appliance in a
horizontal position may lead to
!
irreparable damage to the
components of the heat pump
Permitted transport positions:
No other transport position is authorised
All other transport positions are
!
PROHIBITED
Risk of tipping/falling
Do not drop
or lower suddenly
5
Advertisement
Table of Contents
