Pto Gear Shift Lever; Pto Shaft Cover And Shaft Cap - Kubota M100GX Operator's Manual

68 PTO
PTO 540 / 540E rpm model (if equipped)
BPTO Gear Shift Lever
To avoid personal injury:
A Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
The PTO gear shift lever can be set to either 540 rpm or
540E rpm positions.
Move this lever to either position with the PTO clutch
control switch set to "OFF".

(1) PTO gear shift lever

A For maximum PTO
implements, see the implement Operator's Manual.
A Whenever the PTO speed is changed to the other
speed, it is necessary to switch the PTO speed display
mode of the side digital display. Otherwise the PTO
speed will not get correctly displayed in the side digital
display. (See "SIDE
"OPERATING THE TRACTOR" section.)
(A) 540 rpm
(N) "NEUTRAL POSITION"
(B) 540E rpm
shaft speeds of various
DIGITAL DISPLAY"
BPTO Shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times. Replace
the PTO shaft cap when the PTO is not in use. Before
connecting or disconnecting a drive shaft to PTO shaft, be
sure engine is "OFF". Raise up the PTO shaft cover.
Afterward be sure to return the PTO shaft cover to the
"NORMAL POSITION".
(1) PTO shaft cover
(2) PTO shaft cap
A The universal joint of the PTO drive shaft is technically
limited in its moving angle. Refer to the PTO Drive
Shaft Instructions for proper use.
in
(A) "NORMAL POSITION"
(B) "RAISED POSITION"