Bottom Limit Control Dial; Lift Arm Top Limit Adjustment Dial; 3-Point Hitch Lowering Speed Adjustment Dial; 3-Point Hitch Lowering Lock Lever - Kubota M100GX Operator's Manual

78 HYDRAULIC UNIT
BBottom Limit Control Dial
This dial is used to change the bottom limit of the 3-point
hitch.
1. Turn the dial in the "UP" direction, and the bottom limit
of the hydraulic control lever will raise.
2. Turn the dial in the "DOWN" direction, and the bottom
limit of the hydraulic control lever will lower.

(1) Bottom limit control dial

(2) Hydraulic control lever
(3) Bottom limit
BLift Arm Top Limit Adjustment Dial
This dial is used to change the top limit of the 3-point hitch.
1. Turn the dial in the "HIGH" direction, and the top limit
of the 3-point hitch will raise.
2. Turn the dial in the "LOW" direction, and the top limit
of the 3-point hitch will lower.

(1) Lift arm top limit adjustment dial

A Utilizing the lift arm top limit adjustment dial, the 3-P.
Lifting / Lowering switch and the hydraulic control lever
can be used to adjust the top limit to any level.
(A) "UP"
(B) "DOWN"
(A) "HIGH"
(B) "LOW"
B3-Point Hitch Lowering Speed Adjustment
Dial
To avoid personal injury:
A Fast lowering speed may cause damage or
injury. Lowering speed of implement should be
adjusted to two or more seconds.
This dial is used to change the 3-point hitch's lowering
speed.
1. Turn the dial in the "FAST" direction, and the 3-point
hitch's lowering speed will increase.
2. Turn the dial in the "SLOW" direction, and the 3-point
hitch's lowering speed will decrease.
(1) 3-point hitch lowering
speed adjustment dial
A This dial is not operative for complete hydraulic lock.
For traveling or for checking an implement, set the 3-
point hitch lowering lock lever in the "LOCK" position.
B3-Point Hitch Lowering Lock Lever
To avoid personal injury:
A Before checking 3-point mounted implement,
be sure to lock the implement with the lock
lever. In such case, move the hydraulic control
lever to the "DOWN" position and make sure
the implement does not drop.
This lever has two positions "LOCK" and "UNLOCK". Do
not hold the half way position. When traveling or checking
with the implement raised, set the lever to the "LOCK"
position.
"FAST"
"SLOW"