MOUNTING SCREWS (2) '
$ . . $
0o
WRITE PROTECT SENSOR ASSY.
5.11.2
Ins t a l l ation
A. Using the two original mounting screws, attach the Write Protect Sensor Assembly to the
chassis.
B. Plug P3 into the circuit board.
C. Tie wrap the Write Protect wires to the cable harness.
5.11.3
C hec k s
A. Verify operation of the Write Protect Sensor Assembly.
5.1 2
D OOR SW ITCH ASSE M B L Y
5 .12.1
Re m o v a l
A. Remove P14 from the circuit board.
B. Remove the mounting screw from the door switch bracket (see Figure 5-15).
C. Cut the tie wraps leading to P14.
D. Lift out the Door Switch Assembly.
5.12.2
I ns t a l l ation
A. Mount the Door Switch Assembly to the bridge, using the original mounting screw.
B. Plug P14 into the circuit board.
5 .12.3
Chec k s
A. Ensure that the door switch operates properly.
P2 P3
P I
Oo
Figure 5-14
Write Protect Sensor Assembly Key Parts
5-1 2