Diskette Lever Adjustment; Bridge Assembly Key Parts - Tandon TM848-1 Operating And Service Manual

0 p
BEZEL
SCREWS
2 BOTH SIDES
D. Carefully pull out the two index L. E. D.'s in the Bridge Assembly.
E. Carefully lift out the Bridge Assembly toward the back of the drive. The shaft must clear the
bezel.
5.6.2 Installation
A. Insert the shaft into the bezel and lay the Bridge Assembly in place.
B. Install and tighten the four bridge mounting screws that attach the Bridge Assembly to the
chassis.
C. Install the two index L . E. D.'s into the Bridge Assembly.
D. Install the diskette lever (see Section 5.5.2).
E. Install the circuit board (see Section 5.3.2).
5.6.3 Checks
A. Ensure that the diskette lever clamps the cone and loads the head (see Figure 5-9).
Qo
Figure 5-7

Diskette Lever Adjustment

0o
0 0
Figure 5-8

Bridge Assembly Key Parts

5-7
BRIDGE MOUNTING SCREWS
2 BOTH SIDES
BEZEL
MOUNTING SCREWS, 2
BEZEL
~ DISKE T T E LEVER
BEZEL
MOUNTNG SCREWS. 2
o
o