Track 00 Sensor; Track 00 Sensor Assembly Key Parts 5-1 - Tandon TM848-1 Operating And Service Manual

TRACK 00
SENSOR
ASSEMBLY
MOUNTING
SCREWS
2
0 . 0 +
BRACKET
0o
TIE WRAPS
C. Remove the P2 wires from the bracket attached to the chassis.
D. Remove the two mounting screws that hold down the Track 00 Sensor Assembly.
E. Lift off the Track 00 Sensor Assembly.
5.10.2 Ins t a l l at ion
A. Using the two original mounting screws, install the Track 00 Sensor Assembly.
B. Loop the P2 wires from the Track 00 Sensor Assembly through the bracket attached to the
chassis.
C. Using tie wraps, cable harness the P2 wires and the other wires together.
l3. Plug P2 into the circuit board.
5 .10.3 Ch ec k s
A. Adjust the Track 00 sensor (see Section II).
5 .11 W R I T E P R O T ECT SEN SO R ASS E M B L Y
5 .11.1 Re mo v a l
A. Remove P3 from the circuit board.
B . Remove the two m o u nting screws that attach the Write Protect Sensor Assembly to t he
chassis (see Figure 5-14).
C. Cut the tie wraps that hold the wires to the cable harness, and lift out the Write Protect Sensor
Assembl y .
P2 P S P I
Qo
Figure 5-13
Track 00 Sensor Assembly Key Parts
5-1 1