Table of Contents
Advertisement
DRIVE
MOTOR
C. Carefully rebundle the wires, including the drive motor wire, and cable harness them (see
Figure 5-2).
D. Plug P6 into the circuit board.
E. Turn the drive over, and reinstall the drive belt (see Section 5.1.2).
5.2.3
C hecks
A. Check to ensure that the drive motor works.
B. Check the spindle speed (see Section II).
5 .3
CI RCU I T B O A R D
5.3.1
R emo va l
A. Remove all the connectors from the circuit board.
B. Remove the two side mounting screws that connect the two regulator heat sinks to the drive's
chassis (see Figure 5-3).
C. Remove the screw and the retaining clip that attach the circuit board to the dirve's chassis.
D. Lift the circuit board away from the drive.
E. Remove the power connector by pushing down on its top. Lift its wires out, using the slot
provided (see Figure 5-3).
5.3.2
Installation
A . Install the p o we r c o n nector by r e t h reading th e p o we r w i res an d p u s h ing in th e p o w e r
connector from the back of the drive.
0
p
Oo
0o
MOUNTING SCREWS
(3 PLACES)
DRIVE MOTOR WIRES
Figure 5-2
Drive Motor and Related Parts
5-3
P6
TIE WRAPS
(12 PLACES)
Advertisement
Table of Contents
