Front Lift And Weight Assembly - Land Pride Accuz Z52 , Z60, Z72 Operator's Manual

Section 1 Assembly and Set-Up
5. Install bagger (#1) through brackets and secure with
pins (#2).
6. Assemble clamps (#3) on the ends of the bagger tube
(#4) and slide the tube over the bagger inlet and the
blower as shown in Figure 1-9 and tighten clamps.
Bagger Assembly
Figure 1-9

Front Lift and Weight Assembly

(For Blade Service or Replacement)
IMPORTANT: Do not use jack to support mower while
working under the deck. Chock back wheels and
securely block unit up before working under the deck.
1. The front weight bracket (#1) will mount to the front of
the mower frame with the four u-bolts (#2) lock
washers (#3) and nuts (#4) on the Z60 & Z72 mowers.
The Z52 mounts with two u-bolts (#2) on the right side
and one bolt (#7) and nut (#4) on the left side of
frame as shown in Figure 1-10.
2. Fill the weight (#5) with sand and secure to
weight bracket with bolts (#8), lock washers (#9)
and flat washers (#10).
3. Assemble jack (#6) to the jack mount on the
weight bracket.
12 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
Front Lift and Weight Assembly
Figure 1-10
NOTE: Lubricant can be used when installing tube to
bagger so the tube will slide over bagger inlet easier.
Land Pride
19911
Z52 Left Side
19909
03/11/03