Section 1: Assembly & Set-Up; Tractor Requirements; Electrical Hook-Up; Drawbar Set-Up - Land Pride 315-507M Operator's Manual

All-flex grooming mower
Table of Contents

Advertisement

Section 1: Assembly & Set-up
Section 1: Assembly & Set-up

Tractor Requirements

Tractor horsepower should be within the range noted
below. Tractors outside the horsepower range must not
be used.
Horsepower Rating. . . . . . . . . . . 30-65 hp (22-48 kW)
Rear Power Take-Off Shaft Type . . . . . 1 3/8"-6 Spline
Rear Power Take-Off Speed . . . . . . . . . . . . . 540 rpm
Hitch Type. . . . . . . . . . . . . . . . . . . . . . . . . . . Draw Bar
Hydraulic Outlets . . . . . . . . . . . . . One Duplex Outlet
Electrical Hook-up (See Figure 1-1:). . . . .7-Pin Outlet
Tractor Weight . . . . . . . . . See Important Note Below
Positive Hitch Weight on Tractor Drawbar . . . . . . . . . .
. . . . . . . . . . . . . . . Approximately 500 lbs (2268 kg)
Ballast requirements. . . . . . See important note below
!
WARNING
To avoid serious injury or death:
Lightweight tractors with rear attached implements may need
weights added to the front to maintain steering control.
Consult your tractor Operator's Manual to determine proper
weight requirements and maximum weight limitations.

Electrical Hook-up

Refer to Figure 1-1:
The LED wire harness is equipped with a 7-way round pin
connector for connecting to the tractor's 7-pin electrical
outlet shown in Figure 1-3.
11640
Tractor 7-Pin Electrical Outlet
Figure 1-1
16
AFM4211 All-Flex Grooming Mower 315-507M
Table of Contents

Drawbar Set-Up

Refer to Figure 1-2:
!
DANGER
To avoid serious injury or death:
Do not use a power take-off adapter. The adapter will increase
strain on the tractor's power take-off shaft causing possible
damage to shaft and driveline. It will also defeat the purpose
of the tractor's power take-off shield.
!
WARNING
To avoid serious injury or death:
Do not use a tractor that is too small or too large. Small
tractors can be pushed around and flipped over. Large
tractors can damage the attached implement.
Power take-off damage may occur if distances are not
properly maintained.
The 14" between center of drawbar hitch pin hole to end
of power take-off shaft and 8" from top of drawbar hitch to
center of power take-off shaft must be maintained.
IMPORTANT: power take-off damage may occur if
14" & 8" distances are not properly maintained.
22273
14"
Power Take-Off Shaft
Drawbar
Ground Level
Power Take-Off to Drawbar Distances
Figure 1-2
8"
18" to 21"
3/8/23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mower afm4211

Table of Contents