Adjusting The Shift Pedal - Yamaha XV19SX(C) Service Manual

EWA13110
WARNING
After bleeding the hydraulic brake system,
check the brake operation.
L LLL L LLL L L LLL L L LLL L
3. Install:
• Rider seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21380

ADJUSTING THE SHIFT PEDAL

NOTE:
The shift pedal position is determined by the in-
stalled shift rod length "a".
1. Measure:
• Installed shift rod length "a"
Incorrect → Adjust.
Installed shift rod length
XV19S(C)/ XV19M(C)/
XV19CTS(C)/ XV19CTM(C):
312.0–316.0 mm (12.28–12.44 in)
XV19CS(C)/ XV19C(C):
345.0–349.0 mm (13.58–13.74 in)
A
B
A. For XV19S(C)/ XV19M(C)/ XV19CTS(C)/
XV19CTM(C)
B. For XV19CS(C)/ XV19C(C)
2. Adjust:
• Installed shift rod length
M MMM M MMM M M MMM M M MMM M
a. Loosen both locknuts "1".
L LLL L L LLL L LLL
a
a
M MMM M M MMM M MMM
3-25
b. Turn the shift rod "2" in direction "a" or "b" until
the specified installed shift rod length is ob-
tained.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
NOTE:
• Make sure that the exposed thread length "c"
between the locknut and joint on both ends of
the shift rod is 10 mm or less (for XV19S(C)/
XV19M(C)/ XV19CTS(C)/ XV19CTM(C)).
• Make sure that the exposed thread length "c"
between the locknut and joint on both ends of
the shift rod is 7 mm (for XV19CS(C)/
XV19C(C)).
A
1
a
B
1
a
b
c
A. For XV19S(C)/ XV19M(C)/ XV19CTS(C)/
XV19CTM(C)
B. For XV19CS(C)/ XV19C(C)
c. Tighten both locknuts.
Locknut (shift rod)
12 Nm (1.2 m·kg, 8.7 ft·lb)
d. Make sure the installed shift rod length is
within specification.
L LLL L LLL L L LLL L L LLL L
CHASSIS
b
2
c
2
L LLL L L LLL L LLL