Quick-Release Latch Rack Ear Assembly - HP ProLiant DL180 Gen9 Service Manual

Front I/O assembly removal in an SFF chassis
o
To replace the component, reverse the removal procedure.

Quick-release latch rack ear assembly

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 30).
3.
If installed, remove the security bezel
4.
Remove the access panel
5.
If an expansion board is installed in the primary PCI riser cage, then remove the PCI riser cage
6.
("Remove the PCI riser
Release the front I/O cabling from the server:
7.
Detach the ambient thermal sensor cable from its clip.
a.
Release the ambient thermal sensor cable from the front chassis cable clip.
b.
Disconnect the USB 3.0 cable.
c.
Disconnect the front I/O assembly cable.
d.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Remove the security bezel
("Access panel" on page 37).
cages" on page 31).
(optional)" on page 27).
Removal and replacement procedures 70