Konica Minolta 7085/FORCE 85 Service Manual page 811

(3) Install the fan unit. (TP screw M3x4: 2 pcs.)
TP screws
M3 4
(4) Remove the rear cover of the finisher (6 screws).
(5) Connect the wire bundle connectors for the fan
unit (2 places).
• Connect Connector 1 to the Finisher relay wires.
• Connect Connector 2 to the board, as shown in
the diagram. Make sure that the wires are pulled
through in front of the shaft.
• Process the fan unit wires to the wire saddles (6
locations), as shown in the diagram below.
Caution:
Make sure that the wires for the fan unit will not
touch the shaft of the Finisher.
Wire saddle
processing wire
bundle
Connector-2
Finisher (rear)
(6) Install the guide to the upper right side of the
stacker front. (TP screw M3x4: 3 pcs.)
TP screws
M3 4
Shaft
Connector-1
/Finisher relay wires
Guide
E-11
(7) Reinstall the stacker stopper screws that you
removed in Step 3 (2 screws).
(8) If the Punch Kit is installed in the Finisher, stick
the Punch Label 2 on the handle of the waste
basket.
Stick the Punch Label 1 on the PZ-108 waste
basket.
Punch label/2
Waste basket
(9) Re-Install the rear cover of the finisher (6
screws).
4. Install the front-door assembly to the front door of
the Finisher.
(1) Remove the Exterior connection plate/2 from
the front door assenbly (2 screws).
Screws
(2) Install the exterior connection plate/3 to the
front-door assembly using the two screws
removed in the previous step.
Screws
Punch label/1
Waste basket
Exterior connection
plate/2
Exterior connection
plate/3