Table of Contents
Advertisement
RS-232 Default Parameters
Table 6-1
lists the defaults for RS-232 host parameters. To change any option, scan the appropriate bar code(s)
provided in the Parameter Descriptions section beginning on page 6-4.
NOTE See
miscellaneous default parameters.
RS-232 Host Default Table
Table 6-1
Parameter
RS-232 Host Parameters
RS-232 Host Types
Baud Rate
Parity
Check Receive Errors
Hardware Handshaking
Software Handshaking
Host Serial Response Time-out
RTS Line State
Stop Bit Select
Data Bits
Beep on <BEL>
Intercharacter Delay
Nixdorf Beep/LED Option
Ignore Unknown Characters
1
User selection is required to configure this interface and this is the most common selection.
Appendix A, Standard Default Parameters
for all user preferences, hosts, symbologies, and
Default
1
Standard
9600
None
Enable
None
None
2 Sec
Low RTS
1
8-Bit
Disable
0 msec
Normal Operation
Send Bar Codes
RS-232
Page Number
6-6
6-10
6-14
6-17
6-18
6-21
6-24
6-27
6-28
6-29
6-30
6-31
6-34
6-36
6 - 3
Hide quick links:
Advertisement
Table of Contents
