Battery Replacement - Montigo 34FIDN-L-F Installation & Maintenance Manual

I-Series Indoor Gas Fireplace

Battery Replacement

We recommend that the batteries in this appliance be replaced at the
start of each heating season even if they appear to be operational.
You do not want to find out that you have dead batteries during a
harsh winter storm. If you use your appliance a lot, they may need to
be replaced more than once a year. See the section on Installation
for information on the Battery installation for the Controller Backup.
See the section on Remote Operation for information on how to
install batteries in the hand held Remote Control.
Page 52
Maintenance
Heat Exchanger Bypass
This appliance was designed and built to meet newly proposed
rules of efficiency proposed by Federal Regulatory Agencies. A
great deal of engineering time was spent to ensure this appliance
would provide years of reliable and durable service while operating
at a very high efficiency level. Keeping this in mind, there may
be several conditions where this level of efficiency may not be
desirable. If you are operating this appliance at a very high altitude
or in extremely cold climates, start-up may be difficult. There may
also be a situation where the high level of efficiency isn't wanted
such as if the unit is located in a very small room and the heat output
is simply too great. An optional bypass has been designed into
the heat exchanger which when removed reduces the operational
efficiency by approximately 10%. If it is desired, you can utilize
the bypass by following these simple steps.
1). Always disconnect the electrical supply to the appliance. Shut
off the fuel supply to the appliance before any service work is done.
2). Remove the Door, Firebox Panels and Burner. See the appropriate
sections in this manual for instructions on those procedures.
3). Remove the right and left hand Upper Firebox Liner Retainers.
Figure 29 Sec.6
XG0514-150204