Table of Contents
Advertisement
I-Series Indoor Gas Fireplace
Installation
Connecting Power
Please refer to the specification for power supply requirements.
This appliance is supplied with a Power Cord located on the right
side of the appliance. It can be connected directly to a standard
electrical outlet.
Battery Installation / Replacement
The 34FIDV-LIN uses 2 different sets of Batteries. The Control
Backup uses 4x AA batteries to continue operations during power
outages. The Remote Control uses 3x AAA Batteries for general
operation. The Control Backup Batteries should be changed on
a regular basis regardless of if they have been used or not so
that in the event of a power failure, you will continue to have an
operational heating appliance. To replace the Controller Backup
Batteries, remove the Front Faceplate and remove and re-install
new batteries into the Battery Holder located just above the main
Control Board.
Figure 82 Sec.4
Figure 83 Sec.4
Page 30
XG0514-150204
Advertisement
Table of Contents
