Leds On The Nonport Side Of The Switch; Nonport Side Components; Gbe Copper Port Status Led Patterns - IBM SAN06B-R Installation, Service And User Manual

GBE copper port status LED patterns

The switch has two LEDs (one green and one amber) above each GBE copper port
( 13 and 14 in Figure 9 on page 26) to indicate how that particular port is
functioning. Table 12 describes the meaning of different displays of the port LEDs
and recommended action, if any.
Table 12. GBE copper port status LED patterns
LED color Status of hardware
No lights (both Port is offline
LEDs are off)
Steady green, amber Port is online (connected to external
off device) but has no traffic.
Flickering green, Port is online and data is flowing
amber off through the port.
Green off, steady Port is faulty
amber

LEDs on the nonport side of the switch

The LEDs on the nonport side of the switch provide status information for the two
power supply/fan assemblies. Figure 10 shows the location of these LEDs and
other components on the nonport side of the switch.
Figure 10. Nonport side components
Power supply/fan status LED patterns
Each power supply/fan assembly has one LED ( 4 and 8 in Figure 10) next to
the AC power switch. This LED indicates the status of the power supply and the
fan. Table 13 on page 30 describes the meaning of different displays of the LEDs
and recommended action, if any.
11
3 4 5
1
Fan and power
supply assembly 2
2
Fan and power
supply assembly 1
3
Fan assembly 2
4
FRU LED
5
Power supply 2
6
Fan assembly 2
Recommended action
v Verify that power LED is on.
v Check the transceiver and cable.
No action required.
No action required.
Reset the switch from the workstation. If the fault
persists, use the other copper port or the optical
ports, or contact IBM.
1
6 7
7
Fan assembly 1
8
FRU LED
9
Power supply 1
10
Fan assembly 1
11
FRU handle
12
FRU handle
Chapter 3. Operating the SAN06B-R
12 2
8 9 10
29