Copying Problems - Toshiba e-studio 207l Troubleshooting Manual

2 TROUBLESHOOTING FOR COPYING

Copying Problems

See the table below when you have a problem in operating copy function or have an unexpected copy output.
Problem Description
Functions cannot be set.
Copying stops while
scanning the originals.
(The message "The
number of originals
exceeds the limits Will
you print out stored
originals?" appears.)
Copying stops while
scanning the originals.
(The message "Not
enough Work Space to
store originals Will you
print out stored originals?"
appears.)
Copied image is too light.
Copied image is too dark.
Copied image has stains.
Copy image is skewed.
82 Copying Problems
Cause
Another function that is
unavailable for the
combination has already been
set.
The number of scanned
pages has reached the
maximum.
No available internal memory
remains.
No toner is left.
Copy density is set too light.
Copy density is set too dark.
The Original Cover (optional)
or the Reversing Automatic
Document Feeder (optional) is
not fully lowered.
The original glass, platen
sheet, scanning area and
guide are stained.
The copy density is set too
dark.
A transparent original such as
a transparency or tracing
paper is being used.
The original is sent from the
Reversing Automatic
Document Feeder (optional)
at a skew.
The gap between the paper
and the side guides in the
drawer or the bypass tray is
too large.
Corrective Action
Some functions cannot be combined.
For details, refer to Chapter 8 of the Copying
Guide.
To copy the scanned images, press [YES]. To
cancel, press [NO].
To copy the scanned images, press [YES]. To
cancel, press [NO].
The message "Install new toner cartridge"
appears when no toner is left. Replace the
toner cartridge.
 P.61 "Replacing a Toner Cartridge"
Darken the density manually or try the
automatic density mode.
Lighten the density manually or try the
automatic density mode.
Lower them fully to block the outside light.
Clean them.
 P.139 "Regular Maintenance"
Lighten the density manually or try the
automatic density mode.
To copy a transparent original clearly, put a
sheet of blank, white paper behind the original.
Make sure that the paper is large enough to
cover the original.
Replace the original while aligning the side
guides of the Reversing Automatic Document
Feeder to its width so that it will be placed
straight.
Adjust the gap between the paper and the side
guides so that it becomes appropriate.
For details, refer to Chapter 1 and 2 of the
Copying Guide.