Table of Contents
Advertisement
Chapter 1
Installing the Printer
This chapter explains how to unpack and install the printer. The topics covered are:
Positioning the printer
Unpacking and inspection
Names of parts
Setting up and interfacing
1.1.
Positioning the Printer
Clearance
Allow at least the necessary minimum clearance around the printer (see below). A total space of 92 cm by
61 cm by 138 cm (36 by 24 by 54 inches) is needed.
30 cm (12 inches)
60 cm (24 inches)
Places to Avoid
Avoid installing the printer in locations subject to:
Direct drafts of hot or cold air
Direct drafts from outside (Avoid locations near doors leading outside.)
Sudden temperature or humidity changes
Sources of high temperature, for example, near stoves or radiators
Excessive dust
Vibration
Ammonia or other harmful fumes. (If you are planning to fumigate the room, or make liberal use of insec-
ticide, remove the printer first!)
Excessive sunlight or humidity
Lack of ventilation
Low air pressure, e.g., located more than 2000 meters (6500 feet) above sea level
30 cm (12 inches)
25 cm (10 inches)
1.1. Positioning the Printer
Face-up Output Tray (option)
20 cm (8 inches)
[40 cm (16 inches) when the
optional face-up output tray is
installed.]
For details, refer to page 1-12.
1-1
Advertisement
Table of Contents
