Table of Contents
Advertisement
8—Connect the printer to the computer
The printer has one computer cable connector and a slot for installing an optional interface. The one marked
"
" is for a parallel (Centronics standard) interface. You may also use an optional interface (IB-10), if you
have already have one installed. All interface connectors can be used simultaneously with different computers.
Parallel Interface
Connector
Only connect or disconnect cables to the connectors while the printer and computer power are
switched off.
Parallel interface
Plug one end of the cable into the connector marked Par-
allel on the printer. Close the clips on both sides to hold
it in place.
Plug the other end into a parallel (Centronics) interface
connector on your computer. This connector is usually
marked PRINTER.
See Appendix C for more details about the parallel
interface.
9—Attach the power cord
1.
Check that the power switch is off.
2.
Plug one end of the power cord into the receptacle at
the back of the printer.
3.
Plug the other end into the wall outlet.
Option Interface
Slot Cover
Printer Cable
Power Cord
1.4. Setting Up and Interfacing
Clips
Power Cord
Receptacle
Rear Panel
1-13
Advertisement
Table of Contents
