C.3. RS-232C/RS-422A Protocol
C.3.
RS-232C/RS-422A Protocol
A protocol is a set of rules the computer follows in sending data to the printer. The RS-232C/RS-422A param-
eters are stored in battery backed-up memory. They are indicated on the status printout. They can be
changed by the FRPO (firmware reprogram) command described in the Programming Manual. The param-
eters and their identification codes are given below.
H1: Baud rate
Parameter value
12
24
48
96
19
38
57
11
The factory setting is 9600 baud.
H2: Data bits
7 or 8, factory-set to 8.
H3: Stop bits
1 or 2, factory-set to 1.
H4: Parity
Parameter value
0
1
2
3
The factory setting is "None" (0 on the status printout).
H5: Protocol logic
Parameter value
0
1
2
3
4
5
The factory setting is 0.
H6: Buffer nearly-full threshold
This is a percentage from 0 to 99. The factory setting is 90.
C-6
Baud rate
1200
2400
4800
9600
19200
38400
57600
115200
Meaning
None
Odd
Even
Ignore
Meaning
Combination of 1 and 3 below
DTR/DSR, positive logic
DTR/DSR, negative logic
XON/XOFF
ETX/ACK
XON/XOFF recognized only as protocol