Toshiba RAV-SM567CTP-E Service Manual page 93

No. Part name
Heat
10
1. Detachment
exchanger
1) Recover the refrigerant gas and then
2) Perform works of 1 of
3) The screw that is the fixing of the piping
4) The screw of the partition plate is
5) The screw of the heat exchanger on the
2. Attachment
1) Attach as before in heat exchanger
2) Connect the refrigerant pipe as original, and
SVM-13050.indb 93 SVM-13050.indb 93
Procedure
remove the refrigerant pipe of the
indoor unit.
9
.
Pull out sensor wires from the holder.
support is removed, and the piping
support is removed. (Ø4 x 8, 2 pcs.)
removed while holding the heat
exchanger, the partition plate is removed.
(Ø4 x 8, 4 pcs.)
partition plate and the other side is
removed while holding the heat exchanger,
and the heat exchanger is removed.
sensor piping support drain pan
under panel order.
then perform vacuuming.
– 93 –
FILE NO. SVM-13050
Remarks
Screw
Piping support
Screws
Partition plate
Screw
6/6/13 8:53 AM 6/6/13 8:53 AM