Default Font - Kyocera FS 9530DN Advanced Operation Manual

Default Font

ADVANCED OPERATION GUIDE
8
Press or
9
When the desired pen number is displayed, press [OK].
10
To change the pen width, press
press [OK]. A blinking cursor appears at the
width value.
Press or
pen width in dots (00 to 99) appears. When the desired pen width is
displayed, press [OK].
11
To set the KC-GL page size, press
Page Set is displayed.
12
To change the page size, press [OK].
A blinking question mark (?) appears.
Press or
page size (A2, A1, A0, B3, B2, B1, B0, and
SPSZ) appears. When selecting SPSZ, printing will be done with the paper
size specified by the PRESCRIBE SPSZ command.
13
Press [OK] to set the page set you just selected.
14
Press [MENU]. The display returns to Ready.
You can select the default font for the current interface. In addition to the
internal fonts, all fonts that are downloaded to the printer memory, or fonts
stored on a memory card, hard disk, or option ROM, can be selected as
the default font.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as print a font list.
Selecting the Default Font
1
Press [MENU].
2
Press or
appears.
3
Press to select an internal font, press
or repeatedly until Internal appears.
To select an option font, press [OK] while
> Font Select > is displayed. Press
or repeatedly until the message display indicates Option.This
operation is possible only when option fonts are installed in the printer.
repeatedly until the desired pen number of 1 to 8 appears.
, then
repeatedly until the desired
repeatedly until the desired
repeatedly until Font >
Using the Operation Panel
>>Pen(1) Width
02 dot(s)
, then press or until >KC-GL
>KC-GL Page Set
? [SPSZ]
Font
>Font Select
Internal
>
>
2-45