Printing A Network Interface Status Page - Kyocera FS 9530DN Advanced Operation Manual

Using the Operation Panel

Printing a Network Interface Status Page

2-40
12
Press [OK].
13
Press [MENU]. The message display returns to Ready.
You can print out a status page for the network interface. The network
interface status page shows the firmware version, the network addresses,
and other information under various network protocols about the network
interface. The default setting is On (print). The network interface status
page will be printed out after the printer status page.
NOTE:
Printing out a network interface status page may not be possible
with some optional network interface cards. For details, refer to the
manual for the network interface.
1
Press [MENU].
2
Press or repeatedly until Interface
> appears.
3
Press [OK]. A blinking question mark (?)
appears.
4
Press or
appears.
5
Press [OK] again. The question mark (?)
disappears
6
Press and then press
until the message display indicates
>Network Status Page.
7
The default setting is On. If it is set to Off,
change it as follows. Press [OK]. A blinking
question mark (?) appears.
8
Select On using
repeatedly until Network
or repeatedly
or .
Interface
Parallel
Interface
?Parallel
Interface
?Network
Interface
Network
>Network Status
Page On
>Network Status
Page ? On
>Network Status
Page ? Off
ADVANCED OPERATION GUIDE
>
>