Using the Operation Panel
Received Data Dumping
Printer Resetting
2-90
It is possible to print data received by the printer as hexadecimal code for
the purposes of debugging programs and files.
1
Press [MENU].
2
Press
or
repeatedly until Others >
appears.
3
Press
.
4
Press
or
repeatedly until >Print
HEX-DUMP appears.
5
Press [OK]. A blinking question mark (?)
appears.
6
Press [OK] again. Processing appears
for a second, and then Waiting appears.
7
Send data to be dumped to the printer. The message Processing will be
displayed while receiving the data.
Once the dumped data you require has been printed, it is possible to
cancel the printing of any further dumped data by taking the printer offline
by pressing [GO] and then pressing [CANCEL].
8
Once all data has been received, the message Waiting will appear.
Press [GO] to finish printing.
The procedure described below resets the printer's temporary conditions,
such as the current unit of measurement, page orientation, font, character
code set, margins, etc., set by commands to their default values.
1
Press [MENU].
2
Press
or
repeatedly until Others >
appears.
Others
>Print HEX-DUMP
>Print HEX-DUMP?
Processing
Waiting
Others
ADVANCED OPERATION GUIDE
>
>