Message Display - Kyocera FS 9530DN Advanced Operation Manual

Using the Operation Panel

Message Display

2-4
The message display gives information in the form of short messages. The
nine messages listed below are displayed during normal warm-up and
printing.
Other messages that may appear when the printer needs the operator's
attention are explained on page 4-7 in the Operation Guide.
Message
Self test
Original toner
installed
Please wait
Ready
Processing
Sleeping
Canceling data
Waiting
FormFeed
TimeOut
Meaning
The printer is self-testing after power-up.
The installed toner container is displayed if
determined to be original toner container by
the self-diagnostic performed after power is
switched on.
When using an original Kyocera toner
container, toner remaining warnings and toner
replacement messages are at times displayed
in the operation panel.
The printer is warming up and is not ready.
When the printer is switched on for the first
time after the toner container is installed,
(Adding toner) also appears.
The printer is ready to print.
The printer is receiving data, generating
graphics, reading a memory card/hard disk, or
printing.
The printer is in Sleep mode. The printer
wakes from Sleep mode whenever a key on
the operation panel is pressed, the cover is
opened or closed, or data is received. The
printer then warms up and goes online. The
time that the printer takes to enter Sleep mode
depends on the Sleep Timer setting.
Jobs inside the printer are being canceled. To
cancel a job, refer to the table on page 2-8.
The printer is waiting for the end-of-job
command before printing the last page.
Pressing [GO] allows you to obtain the last
page immediately.
The printer is printing the last page after a
waiting period.
ADVANCED OPERATION GUIDE