Recumbent Cycle: Realigning The Seat - Precor 954i Owner's Manual

Recumbent Cycle: Realigning the Seat

If the seat rocks side-to-side, you need to realign the center wheel
underneath the seat. Adjustment screws are located on the left side of
the seat rail.
To remove seat wobble (side to side movement), take the following
steps.
1. Obtain a ³⁄₁₆-inch and ⁵⁄₁₆-inch hex key.
Diagram 7: Loosen the two adjustment screws
2. Use the ³⁄₁₆-inch hex key to loosen the two adjustment screws as
shown in Diagram 7.
Product Owner's Manual: Maintenance
Diagram 8: Wheel lock adjustment
3. Use the ⁵⁄₁₆-inch hex key to turn the wheel lock adjustment key
clockwise ¹⁄₄ turn. Refer to Diagram 8. This process realigns the
center wheel inside the top rail. Leave the ⁵⁄₁₆-inch hex key in place
while you tighten the adjustment screws with the ³⁄₁₆-inch hex key.
4. Remove the hex keys and check that the seat no longer rocks
side-to-side. If the rocking movement continues, you need to
repeat steps 2 and 3.
30