Accessing Club Programming Mode And Changing The Settings; Treadmill: Selecting Safety Code Protection - Precor 954i Owner's Manual

Accessing Club Programming Mode and
Changing the Settings
Read the Club Programming Tips to identify useful information about
customizing your Precor equipment.
To access the available menus and change the program settings,
perform the following steps:
1. At the Precor banner, press the following keys in sequence
without pausing between selections:
RESET, 5, 6, 5, 1, 5, 6, 5
The club programming prompts appear sequentially and in a menu
format. Refer to Table 3 to determine which keys to use.
Table 3. Club Programming Mode keys
Key
Description
▲ or ▼
Up or down arrow keys
OK key
OK
CLEAR Number keypad CLEAR
key
RESET RESET key
Note: The number keypad is disabled once you enter club
programming mode.
Product Owner's Manual: Club Features
Function
Moves you through the
programs and selections.
Lets you choose or accept
the displayed selection.
Returns to the previous
menu level without saving
any changes.
Exits Club Programming
Mode and returns to the
Precor banner.
Treadmill: Selecting Safety Code
Protection
When the equipment is shipped from the factory, the safety code
protection feature is disabled. If you enable the safety code, your
patrons will need to enter four number keys in sequence to begin their
exercise session and, on the treadmill, start the running belt. If the
correct keys are not pressed within two minutes, further access is
denied. For more information, refer to Entering the Safety Code.
2. At the SAFETY CODE prompt, press OK. Use an arrow key to
alternate between the two selections.
Setting Description
ENABLED Causes the safety code prompt to appear prior to a
workout and when returning from pause mode.
DISABLED Does not require a safety code to operate.
CAUTION: Do not assume the equipment is safe because of
safety code protection. Never leave children unsupervised
around the equipment.
3. When you are ready, press OK to accept the displayed setting and
move to the next feature. For other options, refer to Table 3.
15